Narrative: This photograph was given to my by Greg Lindquist before his exhibition in 2012 at Elisabeth Harris Gallery. The pen's bodies, caps, and plugs are formed from plastic resin. The marker reservoirs are formed from polyester. Powder and water are used to form the felt writing tip. In addition, felt-tipped pens require ink, and the pigments and synthetic substances used to make it. Toluol and xylol are synthetics used as solvents in dye as well as chemicals such as cyclic alkylene carbonates. Conventional additives, such as nonylphenylpolyglycol ether, alkylpoly-glycol ether, fatty acid polyglycol ester, or fatty alcohol ethoxalates, and preservatives, such as ortho-phenolphenyl and its sodium salt, ortho-hydroxydiphenyl, or 6-acetoxy-2,4-dimethhyl-m-dioxane, may also be added to the mixture. To make the body of the marker, plastic resin is injection-molded into a pen's body. Pen caps and plugs are formed in the same manner as the barrel.  The nib, or tip, of the marker is made from powder mixed with water, molded, and baked into its pointed or flat form.

Digital C-prints are the result of printing a digital file on a continuous tone printer that uses silver-based paper. The photograph is created by exposing the paper with light sources (such as lasers or LEDs) and then processing the exposed paper with traditional chemistry. The most common papers are type-C papers processed in RA-4 chemistry. The continuous tone printers include the Lightjet, Durst Lambda, and the Chromira, and labs that make these types of prints will usually advertise that they use one of those three brands.

The thick paper stock was made from pulp obtained by chemical means, known as kraft pulping. Chips of wood were placed in a large, sealed container known as a digester. The digester contained a strongly alkaline solution of sodium hydroxide and sodium sulfide. Bleaching removes lignin and involves mixing the pulp with a series of oxidizing chemicals that react with the lignin. After each mixture, the pulp was washed with an alkaline solution that removes the treated lignin. Fillers were added to the pulp. (A typical filler is a clay known as kaolin. Other chemicals often added to pulp include starches or gums. Rosin and alum are often added as sizers, making the paper less absorbent.) Pulp was added to water to form slurry in order to make paper with an even density. The slurry was pumped onto a moving mesh screen made up of very fine wires of metal or plastic. Water drained through the small openings in the mesh, and formed a sheet of wet material from the slurry. The sheet was moved on a series of belst made of felt containing wool, cotton, and synthetic fibers. The dried sheets moved between rollers known as calendars to make it smooth. After each bleach mixture, the pulp is washed with an alkaline solution that removes the treated lignin. Fillers are added to the pulp. Other chemicals often added to pulp include starches or gums. Rosin (a substance derived from pine trees) and alum (aluminum sulfate) are often added as sizers, making the paper less absorbent. Pulp is added to water to form slurry.